Help modelling a handle

All questions relating to any aspect of 3D modelling with revit should be posted here

Help modelling a handle

Postby Revit69 » Fri Dec 02, 2011 3:54 pm

Could anyone please advise on the best way to model the handle on this dishwasher.........

dishwasher.jpg (14.26 KiB) Viewed 1060 times

I "think" its going to be a Sweep? But the sweeps I have done in the past have all been in a single plane. As you can see, the handle is cranked and then turns through 90 degrees, etc. Can you form a path for a sweep that does this? Or will I have to make up the handle in loads of seperate parts and group them together?

Posts: 21
Joined: Wed Jan 20, 2010 7:16 am

Re: Help modelling a handle

Postby apetitde » Mon May 21, 2012 2:10 pm

You'll have to do separate parts.
Antoine Petitdemange
AXE Architecture - Lyon - France
User avatar
Posts: 18
Joined: Thu Mar 22, 2012 12:29 pm

Return to 3D modelling

Who is online

Users browsing this forum: No registered users and 1 guest