Plinth panels connection

All questions relating to any aspect of 3D modelling with revit should be posted here

Plinth panels connection

Postby Rvt0 » Mon Oct 19, 2015 1:34 pm

Hi!

Happended to view tutorial "Walls: Extending individual layers" today. Was very helpful. But I was wondering, is it possible to do same thing on the plan viewas well, as the tutorial revealed how to do it in section.

In general, as a relatively new Revit user, I can't figure out how to make a decent corner joint for my "plinth panels" (don't know if it's the right word). The problem is, as soon I try to join or cut my wallpanels into proper length I encounter errors. Steel columns move away from their original position etc. Tried to allowing and disallowing wall ends, but didn't get any better. I also tried to use a single layer wall and then "create parts" (using Revit 2015) tool, but didn't get even that far in section as seen in the photo attached. Would appreciate any ideas/solutions, how to get proper corner solution.

Regards,
Attachments
error (Custom).png
error (Custom).png (78.38 KiB) Viewed 166 times
Rvt0
New Member
 
Posts: 2
Joined: Mon Oct 19, 2015 11:43 am

Return to 3D modelling

Who is online

Users browsing this forum: No registered users and 1 guest