Partial decal

by **Reviting** » Mon Dec 09, 2013 3:22 pm

Hi I'm new here, and gradually getting used to the expansive world of Revit 8-)

I've experianced a problem with rendering. As the attachment shows one of my decals is only partially showing. any reason for this?
Any help would be appreciated.

by **Revit Zone** » Mon Dec 09, 2013 3:35 pm

Hi there and Welcome

I'm assuming the decal is coincident with the plane of the wall? If so, strange things do happen sometimes when rendering. Can you stand the decal a few mm off the face of the wall????

Regards,
Ian

by **Reviting** » Mon Dec 09, 2013 4:18 pm

Thanks and nice to be here

Yes I tried to offset the image from the wall but to no avail. Could try attaching it to a thin surface attached to the wall, then hiding the surface.
See if that works, just seems a bit inefficient though.

Partial decal

Partial decal

Re: Partial decal

Re: Partial decal

Who is online