Showing the door leaf in the open / closed positions

[Shrop_Arch]

Hi,

Is there a way to show door leafs in open and closed positions (obviuosly not at the same time)- I want to add a parameter which I can change to either "open" or "closed". This would give a bit of variety to my 3D model.

thanks

[Olly]

Yes, you can do this. Just add a parameter of the "Yes / No" type and use this to control the visisbility of an "Open door leaf" and a "Closed door leaf". ie you will need to door leafs in the family- one in the Open position and one in the closed position and then toggle which one is visible at any one time.

Hi,

Is there a way to show door leafs in open and closed positions (obviuosly not at the same time)- I want to add a parameter which I can change to either "open" or "closed". This would give a bit of variety to my 3D model.

thanks

[Saw]

Or why not just use an "angular" parameter to control the angle of the door leaf geometry? You can then show the door at any angle you choose- not just open or closed.

Mike

Yes, you can do this. Just add a parameter of the "Yes / No" type and use this to control the visisbility of an "Open door leaf" and a "Closed door leaf". ie you will need to door leafs in the family- one in the Open position and one in the closed position and then toggle which one is visible at any one time.

Hi,

Is there a way to show door leafs in open and closed positions (obviuosly not at the same time)- I want to add a parameter which I can change to either "open" or "closed". This would give a bit of variety to my 3D model.

thanks